Orion System VCM-X/RNE Controller - Manual (Page 65)

VCM-X / RNE STATUS
VCM-X / RNE Operator Interface SD 65
Alarm Status
Press . The Unit Selection Screen will be displayed. Enter
the Unit ID of the controller you wish to search and press .
You must type in the number, even if it is “1”. Once communication is
established, the *00* at the top will disappear. Then
press
<

>
.
The System Manager or Service Tool will search for any active alarms
on the unit and the following screen will appear:
VCM-X / RNE v1.00
NO ALARMS OR
ALARMS PRESENT
SCROLL DOWN TO VIEW
Line 2-3 NO ALARMS! OR ALARMS PRESENT
If alarms are present, select VCMX /RNE Alarms or
Module Alarms. Press
<

>
to scroll through all active
alarms.
The screens that follow will display one or more of the
following:
VCM-X ALARMS
NO SUPPLY AIR TEMP
NO OUTDOOR AIR TEMP
SPACE SENSOR FAILURE
RETURN SENSOR FAILURE
MODULE ALARM
MECH COOLING FAILURE
MECH HEATING FAILURE
FAN PROVING ALARM
DIRTY FILTER ALARM
EMERGENCY SHUTDOWN
LO SUPPLY AIR ALARM
HI SUPPLY AIR ALARM
LOW CONTROL TEMP
HIGH CONTROL TEMP
CO2 SENSOR FAILURE
BAD OUTDOOR AIR CFM
TITLE 24 ECONOMIZER AIR TEMP SENSOR FAIL
TITLE 24 ECONOMIZER DAMPER FAIL
TITLE 24 ECONO ECONOMIZING BUT SHOULDN’T
TITLE 24 ECONOMIZER EXCESS OUTDOOR AIR
TITLE 24 ECONO NOT ECONOMIZING WHEN IT
SHOULD
MODULE ALARMS
Head Pressure 1
Head Pressure 2
Full Digital 1
Full Digital 2
WSHP Module 1
WSHP Module 2
Press to select the module. Press
<

>
to
scroll through all active alarms.
For Alarm Defi nitions, see the VCM-X Modular E-BUS
or the RNE Controller Technical Guide.
VCM-X / RNE Status Screens & Alarms