Orion System VCM-X/RNE Controller - Manual (Page 6)

Zone
Zone
SYSTEM CONNECTION
VCM-X / RNE Operator Interface SD 6
Modular System Manager SD
Modular System Manager SD
ENTER
CLEAR ESC
PREV NEXT
DOWN
UP
6 5 4
DEC
7
0
8
1 3 2
9
MINUS
-
STATUS
SETPOINTS
SCHEDULES
ALARMS
OVERRIDES
9.00"
6.25"
1.81"
Figure 3: Modular System Manager SD Dimensions
The OE392-12 Modular System Manager SD provides a direct link to
enable you to view the status and adjust the setpoints of the VCM-X,
VCM-X E-BUS, VCB-X, RNE, SA E-BUS, VCM, VAV/CAV, MUA II
or VAV/Zone Controller on the control system communications loop.
The System Manager SD is housed in a beige-colored plastic enclosure.
The System Manager has a programmable 4 Gigabyte SD card and is
equipped with a 4-line-by-20-character backlighted display panel and
a 24-key membrane keypad for data selection and entry. All keypad
operations are simple and straight forward, utilizing non-cryptic plain
English language messages. Menu-driven programming allows for
easy setup and operation without the need for specialized training. The
System Manager also has 2 integral LEDs for user notifi cation of system
alarm conditions and override initiations. Protection from unauthorized
users is provided by the System Manager’s integral multi-level passcode
authorization programming.
On a Networked System, the Modular System Manager is connected to
the communications and power loop of the system via modular cables
that simply plug into the System Manager board and the Power/Comm
Distribution Board. This virtually eliminates wiring errors and makes
installation fast and easy. When it is to be connected to a Stand-Alone
system, a cable with modular connectors on one end and stripped wire
ends on the other end is provided to facilitate connecting communications
and power to the Modular System Manager from the 24 VAC power
source and the HVAC unit controller communication wiring terminals.
The Modular System Manager is designed for wall mounting. Mounting
holes are provided to attach the Modular System Manager to a standard
handy box. It is recommended that the System Manager be mounted at
approximately eye level to allow for ease of programming and reading
of the display. The System Manager is typically mounted in the build-
ing manager’s or superintendent’s offi ce or in an equipment room. The
attractive enclosure is quite suitable for mounting in any location.