Orion System VCM-X/RNE Controller - Manual (Page 61)

VCM-X / RNE STATUS
VCM-X / RNE Operator Interface SD 61
Status Screen 20 / VCM-X - Full Digital Module
OR Dual Digital Module
VCMX-M/HP Cnfg ID 102
Full Digital Temp
Coil A1: X.Xº F
Coil A2: X.Xº F
Line 2 Full Digital Temperature
If using a VCM-X E-BUS Modular Controller
with a Full Digital Module ( OE370-23-FD-A) or if you are
using the VCM-X E-BUS WSHP Controller with
multiple Digital Scroll Compressors, this screen will
appear.
Line 3 Coil A1 Temperature
This is the current Coil Suction Temperature of
Compressor A1.
Line 4 Coil A2 Temperature
This is the current Coil Suction Temperature of
Compressor A2.
VCMX-M/HP Cnfg ID 102
Dual Digital Temp
Circuit A: X.Xº F
Circuit B: X.Xº F
Line 2 Dual Digital Temperature
If using a VCM-X E-BUS Modular Controller
with a Dual Digital Module ( OE370-23-DD) or if you are
using the VCM-X E-BUS WSHP Controller with two
Digital Scroll Compressors, this screen will appear.
Line 3 Circuit A Temperature
This is the current Coil Suction Temperature of Circuit A.
Line 4 Circuit B Temperature
This is the current Coil Suction Temperature of Circuit B.
Status Screen 20 / RNE - Full Digital Module
RNE Cnfg ID 102
Full Digital Temp
Coil A1: X.Xº F
Coil A2: X.Xº F
Line 2 Full Digital Temperature
If using a Full Digital Module ( OE370-23-FD-A) or
Water Source Heat Pump Module (OE334-23-WPM-A),
this screen will appear.
Line 3 Coil A1 Temperature
This is the current Coil Suction Temperature of
Compressor A1.
Line 4 Coil A2 Temperature
This is the current Coil Suction Temperature of
Compressor A2.
VCM-X / RNE Status Screens
Standard Operation:
0-10 VDC 0% = 0 VDC 100% = 10 VDC
2-10 VDC 0% = 2 VDC 100% = 10 VDC
Reverse Acting Operation:
0-10 VDC 0% = 10 VDC 100% = 0 VDC
2-10 VDC 0% = 10 VDC 100% = 2 VDC
If you do not have a Modulating Heating device confi gured,
this screen will indicate [No Mod Heat Confi g].
Line 4 Indicates That These Are Optional Outputs
These outputs may or may not have live data to display.