Gasboy Islander PLUS - Manual (Page 70)

3-6.6. Pedestal Installation Instructions
Proceed as follows:
1. Remove the four M10 nuts (1 in Figure 3-8) from the four bolts attached to the Bottom
Plate.
2. Insert the Pedestal Base (3 in Figure 3-7) (1 in Table 3-1) on top of the Bottom Plate.
3. Insert the Pedestal Pole (4 in Figure 3-7) (1 in Table 3-1) on top of the Pedestal Plate.
4. Anchor the Pedestal Pole onto the Pedestal Plate with the four bolts (1 in Figure 3-7)
protruding from the inner ground.
5. Secure the Pedestal Pole with four M10 flat washers (4 in Table 3-1) and M10 nuts (1 in
Figure 3-8) (3 in Table 3-1)
6. Insert the Rosette (see Figure 3-9) (6 in Table 3-1) on the Pedestal Base, and secure it to
Pedestal Pole with four M10 flat washers (4 in Table 3-1) and M10 nuts (1 in Figure 3-8)
(3 in Table 3-1).
3-6.7. Base Plate Installation Procedures – Optional
The Base Plate can be attached to the spot ground by four expansion bolts as an option.
Proceed as follows:
1. Set the Bottom Plate (1 in Figure 3-7) (5 in Table 3-1) in the spot and mark the four holes
location for drilling
2. Drill four holes in the installation spot
3. Insert four expansion bolts (see Figure 3-11) in the holes. Check that the bolts protrude
from the Bottom Plate by 1.4" (35 mm).
4. Insert the Bottom Plate on the spot so that its installation holes fit with the protruding bolts.
5. Take care that all power and communication conduits pass through the central hole in the
Bottom Plate
Figure 3-11 Expansion Bolt
7. Insert the Pedestal Base (3 in Figure 3-7) (1 in Table 3-1) on top of the Bottom Plate.
8. Insert the Pedestal Pole (4 in Figure 3-7) (1 in Table 3-1) on top of the Pedestal Plate.
Islander PLUS Manual 56