Gasboy MCE300 - Manual (Page 26)

Configuration
03/07/03 5-5
RESET CARD DATA FILE
The opportunity to reset the card data file is provided at the end of the L (Load Configuration)
command. It is recommended that the file be reset when changes have been made to the
configuration that will affect the data in the file. Reset of the card data file will eliminate any card
data previously loaded into the file. This will also reset the "TOTAL CARDS IN DATA FILE" count
to zero. If a reset is requested, you will be prompted to verify the file should be reset.
Y - Reset the card data file and verify the file should be reset.
N - Do not reset the card data file or cancel the request during the verification sequence.