Fluke Biomedical VT Plus HF - Manual (Page 16)

VT Plus HF
Operators Manual
1-4
• Perform a visual inspection to ensure that the Analyzer is intact and if there is any
physical damage, such as bent or broken parts, dents, or scratches. If the Analyzer
has been damaged, call the Fluke Biomedical Service Center immediately. If the
Analyzer be returned to Fluke for service, follow the procedure given under
Maintenance, Service, and Calibration: Packing Instructions.
• After unpacking the Analyzer, check to see if all of the standard accessories listed
under Accessories have been included with the Analyzer. If anything is missing,
contact the Fluke Biomedical Service Center.
General Safety Considerations
Read the Users Manual before operating the Analyzer.
Symbols
Table 1-1 describes the symbols associated with the Analyzer.
Table 1-1. Symbols
Symbol Description
X
Hazardous voltage
W
Important information; refer to manual
Œ
Conforms to UL Std 3101-1; certified to Can/USA Std C22.2 No. 1010.1
P
Conforms to European Union directives
~ Do not dispose of this product as unsorted municipal waste. Go to Fluke’s
website for recycling information.
Hg Contains mercury. Dispose properly.
Warnings and Cautions
A Warning identifies hazardous conditions and actions that could cause bodily harm or
death.
A Caution identifies conditions and actions that could damage the Analyzer, the
equipment under test, or cause permanent loss of data.
XW Warning
To avoid possible electrical shock or personal injury, follow
these guidelines:
•
Use this Analyzer only in the manner specified by the
manufacturer.
•
Do not use the product if it operates abnormally.
•
Plug the main power cord only into a power outlet that has a
protective earth contact to connect the chassis of the Analyzer to
ground.
•
Do not use extension cords without earth ground, or a hazardous
condition may result.
•
Turn off the Analyzer and disconnect its power cord before
opening the case or performing any service procedures.