Flowserve 3400IQ Digital Positioner - Manual (Page 94)

Logix 3400IQ Digital Positioner FCD LGENIM3402-00 – 0/07
4
INTERNAL_FLAGS: Each bit within this variable is a flag indicating parameters relevant to the internal
operation of the positioner electronics. A logic 1 indicates error is active.
Bit Description
0 0 = No error
1 = 12 bit A/D reference error
1 0 = No error
1 = 1.23V reference error
2 0 = No error
1 = 12 bit DAC error
3 0 = No error
1 = Temperature error
4 0 = No error
1 = Hall Sensor error
5* 0 = No error
1 = Excessive modulator current*
6
7
0 = No error
1 = EEPROM checksum error
* Even though excessive modulator current is being reported, modulator current is not actually
measured in the Logix 3400IQ. The value that is actually being is measured and reported is that the
piezo voltage is out of range.
LOAD_EE_DEFAULTS: This variable will load the positioner’s card EEPROM with factory default
values.
Value Function
1 Reset variables
2 Reset calibration constants
MISC_FLAGS: This bit mapped variable is used to enable/disable various features ofthe Logix 3400IQ
digital positioner. The user does not view it.
Bit Name Function
0 Re-Cal Disable 0 = Re-Cal enabled
1 = Re-Cal disabled
1 Large Act. Cal Enable 0 = Normal calibration
1 = Large actuator calibration
2 Auto Model Detect Disable 0 = Auto model detect enabled
1 = Auto model detect disabled
3 Pressure Control 0 = Pressure control disabled
1 = Pressure control enabled
4 Auto Feedback Gain 0 = Auto feedback gain select disabled
1 = Auto feedback gain select enabled
5 Not used
6 Internal Flags on Position Deviati-
on Alarming
0 = Disabled
1 = Enabled
7 Jog Calibration Set 0 = Disabled
1 = Enabled