Denon AVR-5805CI - Manual (Page 96)

96
Advanced Operation
1 Select the ZONE2 mode using the AMP
button.
2
Press the CH SEL/ENTER button.
• The “Channel Vol.” screen appears.
3
Press the CURSOR D D, H H or CH SEL/ENTER
button then select “Fader”.
The channel switches in the order shown below each
time the CH SEL/ENTER button is pressed.
FADER
SR
SBL SL SBR
FL C FR SW
2 Fader function
• This function makes it possible to lower the volume of the
front channels (FL, C and FR) or the rear channels (SL, SR,
SBL and SBR) of ZONE2 together. Use it for example to
adjust the balance of the sound from each position when
multi-channel music sources are played.
DSP SIMULATION
STANDARD
7CH STEREO
CURSOR
SURROUND
PARAMETER
USER MODE
STEREO
CH SEL/ENTER
AMP
4 Press the CURSOR F F button to reduce the
volume of the front channels, the CURSOR G G
button to reduce the volume of the rear
channels.
The fader function does not affect the SW channel.
ZONE2 surround back speakers are only displayed
when “7.1ch” is selected for the ZONE2 channel
output setting at “Channel Setup”.
When the ZONE2 surround back speaker setting is set
to “1spkr” for “Speaker Configuration”, this is set to
“SB”.
• The channel whose channel level is adjusted lowest can be
faded to –12.0 dB using the fader function.
• If the channel levels are adjusted separately after adjusting
the fader, the fader adjustment values are cleared, so adjust
the fader again.