Denon AVR-5805CI - Manual (Page 120)

120
Advanced Setup – Part 1
Setting the type of speakers for ZONE2
1 Press the CURSOR D D or H H button to select
“Zone Setup” at the “System Setup Menu”,
then press the
ENTER button.
• The “Zone Setup” menu appears.
• Set the presence/absence of speaker combinations and the
size in function of the low frequency reproduction
capabilities when playing surround sound in ZONE2.
4
Press the ENTER button to enter the setting.
• The “Zone Setup” menu reappears.
3 Press the CURSOR D D or H H button to select the
speaker, then press the CURSOR F F or G G button
to select the parameter.
2 Press the CURSOR D D or H H button to select
“Speaker Config.”, then press the ENTER button.
• The “Speaker Config.” screen appears.
Zone Setup (ZONE2 = 5.1/7.1ch)
• Make the settings related to surround playback and video for ZONE2.
• Adjust the sound played in ZONE3 and ZONE4.
ZONE2 Center Sp.
ZONE2 Front Sp.
ZONE2 Subwoofer
ZONE2 Surround Sp.
(ZONE2 Surround back Sp.) *
* This is only displayed when “7.1ch” is selected for
the ZONE2 channel output setting at “Channel
Setup” (
page 126 ~ 128).
For a description of the different parameters (
page 141).
Setting the low frequency distribution for
ZONE2
1 Press the CURSOR D D or H H button to select
“Subwoofer Mode” at the “Zone Setup” menu,
then press the
ENTER button.
• The “Subwoofer Mode” screen appears.
• This selects the subwoofer used in ZONE2 for playing the
low base sound.
3
Press the ENTER button to enter the setting.
• The “Zone Setup” menu reappears.
2 Press the CURSOR F F or G G button to select the
setting.
LFE:
For any channel(s) that are set to LARGE, low
frequencies in that channel’s corresponding source
are directed to that loudspeaker only. Low
frequencies that are directed to the subwoofer(s)
are from the program source LFE channel, and
from other channels where the speakers are set to
SMALL.
LFE+Main:
Low frequencies from speaker channels that have
been set to LARGE are reproduced from those
speakers as well as from the subwoofer(s).
Depending upon the characteristics of the LARGE
main speakers, this mode may provide a more even
low frequency response throughout the listening room.
• The subwoofer mode setting is only valid when “Large” is
set for the ZONE2 front speakers and “Yes” is set for the
subwoofer in the “Setting the type of speaker for ZONE2”.
• When “STEREO” or “MONO” is selected for the ZONE2 channel output setting at “Channel Setup” ( page 126 ~ 128),
the menu screen displayed differs. In this case, see the instructions starting at page 125.