Denon AVR-5805CI - Manual (Page 121)

121
Advanced Setup – Part 1
Setting the Delay Time for ZONE2
• This parameter is for optimizing the timing of the sound
produced from the various speakers and subwoofer
according to the listening position in ZONE2.
1 Press the CURSOR D D or H H button to select
“Delay Time” at the “Zone Setup” menu, then
press the
ENTER button.
• The “Delay Time” screen appears.
2 Press the CURSOR F F or G G button to select the
desired unit, “Meters” or “Feet”.
• The “Delay Time” screen appears automatically.
Example: When “Feet” is selected
3 Press the CURSOR D D or H H button to select the
speaker to be set.
4 Press the CURSOR F F or G G button to set the
distance between the center speaker and
listening position.
Example: When the distance is set to 10.0 feet for the
center speaker
The distance changes in units of 1 foot or 0.1 foot
each time the button is pressed. Select the value
closest to the measured distance.
When “Step” is selected, you can select the unit of “1
ft (0.1 m)” or “0.1 ft (0.01 m)”.
When “Default Yes” is selected, then press the
CURSOR F
F button to reset to the default values.
The difference of the distances set for the various
speakers must be 20.0 ft (6.0 m) or under. If an
inappropriate distance is set, “RELOCATE
BLINKING SP!” is displayed. In this case, move the
relevant speaker to the proper position as
indicated by the displayed value.
5 Press the ENTER button to enter the setting.
• The “Zone Setup” menu reappears.
The AVR-5805CI automatically sets the optimum
surround delay time for the ZONE2 listening room.
h h