beautypg.com

Denon AVR-5805CI User Manual

Page 104

background image

104

Advanced Setup – Part 1

Setting the Digital In Assignment

• This assigns the digital input terminals for the different input

sources.

1

Press the

CURSOR

D

D or H

H button to select

“Audio Input Setup” at the “System Setup
Menu”, then press the

ENTER

button.

• The “Audio Input Setup” menu appears.

2

Press the

CURSOR

D

D or H

H button to select

“Digital In Assign”, then press the

ENTER

button.

• The “Digital In Assign” screen appears.

3

Press the

CURSOR

D

D or H

H button to select the

input source, then press the

CURSOR

F

F or G

G

button to select the digital input terminal.

Select from among COAX 1 to 6, OPT 1 to 5.
If the same digital input terminal is selected, the
setting for the input source that was previously
assigned switches to “OFF”.
The HDMI input terminal is displayed when it is
assigned to the input source at “HDMI/DVI In Assign”
(

page 111, 112).

If an input source is assigned to a device connected
with an IEEE1394 cable at “IEEE1394 Assign”, the
digital input terminal’s assignment setting switches to
“OFF”.
When “Default Yes” is selected, then press the
CURSOR F

F button to reset to the default values.

Audio Input Setup

• Make the audio-related settings.

4

Press the

ENTER

button to enter the setting.

• The “Audio Input Setup” menu reappears.

• The OPTICAL 3, 4 and 5 terminals on the AVR-5805CI’s rear

panel are equipped with an optical digital output terminal for
recording digital audio signals to a CD recorder, MD recorder,
or other digital audio recording deck. Use this for digital
recording between a digital audio source (stereo – 2 channel)
and a digital audio recorder.

• “PHONO” and “TUNER” cannot be selected on the “Digital

In Assign” screen.

• Do not connect the output of the component connected to

the OPTICAL 3 (to 5) OUT terminal on the AVR-5805CI’s rear
panel to any terminal other than the OPTICAL 3 (to 5) IN
terminal.

1

Press the

CURSOR

D

D or H

H button to select the

input source, then press the

CURSOR

F

F or G

G

button to select “DLINK”.

2

Press the

CURSOR

D

D or H

H button to select

“DLINK” setting, then press the

CURSOR

F

F or

G

G button to select the input signal (ANALOG,
EXT. IN or IEEE1394).

If the signal cannot be played with DENON LINK
connection, the signal automatically switches to the
input from the set terminal.

2

Setting the DENON LINK

• When a DENON DVD player and the DENON LINK have

been connected, be sure to make a setting to “DENON
LINK” with the System Setup Digital In Assignment.

• When the input mode is AUTO and the signals are not be

able to transferred by DENON LINK, the unit automatically
changes over the input to the selected signals (ANALOG,
EXT. IN or IEEE1394).

• Refer to “DENON LINK connections” (

page 35).