Denon AVR-5805CI - Manual (Page 44)

44
Basic Operation
Playing the input source
1 Select the input source to be played.
• The input source indicator lights.
Example: CD
(Main unit) (Remote control unit)
To select the input source when ZONE2 SELECT,
ZONE3/4/REC SELECT or TUNING PRESET is
selected, press the SOURCE button on the main unit
then operate the FUNCTION konb.
MATER VOLUME SOURCE FUNCTION
MATER VOLUME
HOME THX
CINEMA
ROOM EQ
SPEAKER
MUTE
VIDEO SELECT
FUNCTION
2 Start playback on the selected component.
For operating instructions, refer to the component’s
manual.
3 Adjust the volume.
The volume can be adjusted within the range of –80.0
to +18.0 dB, in steps of 0.5 dB. However, when the
channel level is set (
page 64, 65 or 134), if the
volume for any channel is set at +0.5 dB or greater, the
volume cannot be adjusted up to 18.0 dB. (In this case
the maximum volume adjustment range is “18.0 dB —
(Maximum value of channel level)”.)
Also, you may not be able to adjust the volume to the
maximum of 18.0 dB when internal volume
compensation control is activated due to the
combination of the surround mode and parameters,
downmixing from multi-channel audio signals into two
channels, etc.
(Main unit) (Remote control unit)
M.VOL. -80.0dB
The volume level is displayed on the master volume
indicator.
2 To choose the surround sound mode
Example: HOME THX CINEMA
Press the HOME THX CINEMA button.
For more information about the surround modes (
page 51 ~ 53).
2 To select the Room EQ function
Press the ROOM EQ button.
For more information about the Room EQ function
(
page 48).
PHONES ROOM EQ MONITOR SELECT
SCALE
VIDEO ON/OFF
SURROUND SPEAKER
HOME THX CINEMA
VIDEO SELECT