Denon AVR-5805CI - Manual (Page 117)

117
Advanced Setup – Part 1
Setting the Dolby Digital Setup
• Turn the audio compression on or off when down-mixing
Dolby Digital signals.
1 Press the CURSOR D D or H H button to select
“Dolby Digital Setup” at the “Advanced
Playback” menu, then press the
ENTER button.
• The “Dolby Digital Setup” screen appears.
2
Press the CURSOR F F or G G button to select
“ON” or “OFF”.
OFF:
The dynamic range is not compressed.
ON:
The dynamic range is compressed automatically
according to the combination of speakers being
used.
Set “Compression” to “ON” if it seems that sound is
distorted because the input level exceeds the
allowable input for the front speakers.
When a center speaker or surround speakers are not
connected, the sounds in those channels are directed
to the front speakers.
3
Press the ENTER button to enter the setting.
• The “Advanced Playback” menu reappears.
1 Press the CURSOR D D or H H button to select
“Auto Surround Mode” at the “Advanced
Playback” menu, then press the
ENTER button.
• The “Auto Surround Mode” screen appears.
2 Press the CURSOR F F or G G button to select
“ON” if you want to use the auto surround
mode, “OFF” if you do not want to use it.
3 Press the ENTER button to enter the setting.
• The “Advanced Playback” menu reappears.
Setting the Auto Surround Mode
• The various settings applied in the auto surround mode can
be checked via the on screen display. Simply press the ON
SCREEN button (
page 52).
• The surround mode used at last for the four types of input
signals shown below is stored in the memory, and the signal
is automatically played with that surround mode the next
time it is input.
Note that the surround mode setting is also stored
separately for the different input sources.
q Analog and PCM 2 channel signals (STEREO)
w 2 channel signals of Dolby Digital, DTS or other multi-
channel format (DOLBY PL II x Cinema)
e Multi-channel signals of Dolby Digital, DTS or other
multi-channel format (DOLBY/DTS SURROUND)
r PCM and DSD multi-channel signals other than Dolby
Digital and DTS (MULTI CH IN)
Default settings are indicated in ( ).
During playback in the PURE DIRECT mode, the
surround mode does not change even if the input signal
is changed.