Avery Dennison SNAP 700 - Manual (Page 87)

User’s Manual—SNAP™ 700 Printer
87
Voice Message Prompt Description
The lower (upper)
print station ink roll is
empty INK OUT BOTTOM (TOP) This error indicates that the ink on the specified print
station is either missing or broken, or the supply roll
is empty.
If this error continues to occur even though the ink
supply rolls are properly installed, remove the ink
rolls and press the Start button. The unwind (supply)
arbor should spin counter-clockwise and the rewind
(take-up) arbor should spin clockwise briefly. If one
or both of the motors does not spin, the motor(s) or
MCB are defective. If both motors spin, install a new
ink roll. If the error continues to occur with the new
ink roll, the MCB is defective.
The lower (upper)
print station roller is
open HEAD OPEN BOTTOM
(TOP)
This error indicates that either the upper or lower
platen roller is open. Close the roller. If the error
continues to occur when the roller is closed, check
the roller open sensor.
Missed sense mark MISSED SENSE MARK The format specifies a sense mark, but no sense
mark was found. Possible causes are misalignment
of the sensor to the sense mark or incompatibility of
the sense mark and the sensor type. Another
possible cause is a mismatch between the label
length that is set in the format with the actual
distance between sense marks on the stock.
NOTE: In later versions of code, this message is
replaced by the following messages that specify the
type of sensor. This gives more information in case
the wrong sensor type is selected.
Missed hole sense
mark MISSED HOLE
SENSEMARK
The format specifies a hole sense mark, but no
sense mark was found. Possible causes are
misalignment of the sensor to the sense mark or
incompatibility of the sense mark and the sensor
type. Another possible cause is a mismatch between
the label length that is set in the format with the
actual distance between sense marks on the stock. If
the format does not specify a hole sense mark, the
sensor type override may be set.
Missed top reflective
sense mark MISSED T REFL
SENSEMARK
The format specifies a top reflective sense mark, but
no sense mark was found. Possible causes are
misalignment of the sensor to the sense mark or
incompatibility of the sense mark and the sensor
type. Another possible cause is a mismatch between
the label length that is set in the format with the
actual distance between sense marks on the stock. If
the format does not specify a top reflective sense
mark, the sensor type override may be set.
Missed bottom
reflective sense mark
MISSED B REFL
SENSEMARK
The format specifies a bottom reflective sense mark,
but no sense mark was found. Possible causes are
misalignment of the sensor to the sense mark or
incompatibility of the sense mark and the sensor
type. Another possible cause is a mismatch between
the label length that is set in the format with the
actual distance between sense marks on the stock. If
the format does not specify a bottom reflective sense
mark, the sensor type override may be set.