beautypg.com

Avery Dennison SNAP 700 User Manual

Page 27

background image

User’s Manual—SNAP™ 700 Printer

27

3. To install the stock supply roll, begin with the leading end at the top of the roll

pulling off towards the stacker.

4. Slide the stock roll onto the Stock Arbor (see Figure 9).

5. Rotate the Stock Arbor knob counter-clockwise quickly to extend the fingers

that hold the supply roll in place.

6. With all print rollers in the open position, pull the stock from the top of the

supply roll, and over the Decurler Roller.






Figure 9. Stock Supply through Print Stations

7. Pull the roll of stock to the right of the Stock (web) guides.

8. Feed the web between the two plates that support the registration sensors

9. Continue threading the stock between the print rollers and through the feed.

10. Rotate the black knob on the feed counter-clockwise and advance the stock

through the knife and nip rollers and into the stacker (until it extends about ½
inch or 10 mm - 15 mm from the rollers).

11. If the stock will not advance through the knife, refer to Section 5.4.2, Knife

Home Position Adjustment.

12. Rotate the stock web guide knob to align it to the stock width.

13. Close the upper and lower print rollers.

Decurler Roller

Stock Arbor Knob

Retraction

Fingers

Stock (Web) Guide

Upper Print Station

Lower Print Station

This manual is related to the following products: