Avery Dennison SNAP 700 - Manual (Page 43)

User’s Manual—SNAP™ 700 Printer
43
Figure 14. Stacker Angle – Almost Vertical
4.2.4 Platform
The platform angle can be adjusted in two different locations to alter the angle at
which labels are stacked and stopped.
1. Pull the spring loaded Adjustment Pin and move the platform from a
horizontal to a backwards angle approximately 20 degrees up on the outer
end of the platform.
a. For satin labels, use the lower position.
b. For coated labels, and short feed labels, elevate the outer end.
The label stop helps position the labels in the stack. The label stop is magnetic.
Follow these steps to adjust the position of the label stop.
2. Place a cut label on the stacker platform and slide it into the back corner.
3. Move the label stop to within 1/8 inch (3 mm) of the end of the label.
Platform
Stacker Sensor
Switch
Label Stop
Rotary Knife
Assembly
Shafts
Nip Roller
Adjustment
Pin