3 determining the dhcp address – Avery Dennison SNAP 700 User Manual
Page 52
52
User’s Manual—SNAP™ 700 Printer
There are two Ethernet connectors on the back of the printer. One is on the
motherboard and is not used. You need to have a network interface card
installed on the printer to use it. Contact Avery Dennison Customer Service
if you need a card. It can be installed in the field
Because the DHCP process may take some time, wait at least 1 minute after the
printer finishes its initialization (Ready light is on steady) before continuing.
4.4.3 Determining the DHCP Address
To find out the DHCP address that was assigned to the printer, you can print out
the Network ID Test Label. Load the printer with stock and ink and then follow
this procedure.
1. Press and hold the Voice button. Listen for “Press Start to print test patterns”
2. Press the Start button. “Press Start to print narrow setup test pattern”.
3. Press the Voice button. “Press Start to print wide setup test pattern.”
4. Press the Voice button. “Press Start to print Custom Test Pattern One.”
5. Press the Start button. “Ready to print Custom Test Pattern One. Returning to
print mode.”
6. The Data light will come on. Press Start to begin printing the Network ID Test
Pattern.
7. The Network ID Test Pattern label will have the temporary IP address printed on
it, see the picture below. If there is no IP address, there may be a problem with
your network connection. Check the connection and try again. If you can’t resolve
the problem, contact your Network Administrator.
Network Interface Card
Motherboard. Do not use.