Installation procedure - electrical – Avery Dennison SNAP 700 User Manual
Page 108
108
User’s Manual—SNAP™ 700 Printer
Installation Procedure - Electrical
1) Facing the back of the Printer, remove the existing connector plate and
screws and discard.
REMOVE
REMOVE
2) Assemble Internal Verifier Cable into slot and secure with hardware
supplied on 581129.
581129 - INTERNAL VERIFIER CABLE
3) Mount J1 (5 wire, 10 pin connector) to MCB J7. Mount J2 (3 wire, 10 pin
connector) to MCB J11.
4) Assemble External Verifier Lead Connector to mating Connector in
internal cable (installed in step 2) & mating Connectors to top of Verifier.