4 cut / stack – Avery Dennison SNAP 700 User Manual
Page 84
84
User’s Manual—SNAP™ 700 Printer
8.4 Cut / Stack
Problem
Probable Cause
Corrective Action
Machine fails to cut
labels
(the
rotary
knife does not rotate).
1) The knife is disabled.
1) Enable the knife in the setup menu via the
Virtual Control / Display in PCMate
Platinum section 8.0.
2) Cut count is set to “0” in the
Design File.
1) Refer to the PCMate Platinum software
manual.
The
stacker
platform
fails to run.
1)
The
stacker
cable
is
disconnected.
1) Power off the machine and insert the
stacker cable in the stacker port.
Labels will not stack.
1) Stacker is not operating.
1) Be sure the nip roller is free to rotate.
2) Stacker position on the
machine too high or too low.
1) Move the toggle switch to the opposite
position.
3) Incorrect position platform bed
angle.
1) Use the pull pin to change the platform
angle.
Knife
does
not
cut
completely through.
1)
Knife
blade
shear
is
misaligned.
1) Refer to section 6.4, Knife Shear
Adjustment.
Knife will not cut.
1) Knife blades are dull.
1) Refer to section 5.4.1, Removing and
Replacing the Knife assembly.
IF THE RECOMMENDED CORRECTIVE ACTIONS DO NOT
RESOLVE THE PROBLEM (S), CONTACT YOUR LOCAL
AVERY DENNISON REPRESENTATIVE.