5 setting up the printer, 1 attaching the stacker – Avery Dennison SNAP 700 User Manual
Page 17
User’s Manual—SNAP™ 700 Printer
17
2.5 Setting up the Printer
2.5.1 Attaching the Stacker
Figure 4. Rotary Knife and Stacker
The stacker and knife are two separate assemblies that can be installed and/or
replaced easily and quickly. For information on adjusting the stacker, refer to
Section 4.2.
1. Locate the two shafts on the printer below the Auxiliary Feed and Knife
assembly (see Figure 4).
2. Slide the stacker onto the two shafts until the backside of the stacker is
beyond the stock size to be run.
NOTE: Be sure to slide the top of the stacker behind the
Nip Roller stripping plate.
3. With the power off, connect the stacker cable extending from the bottom of
the stacker assembly into the larger connector on the right side of the printer.
Rotating the connector and applying light pressure inward will help engage
the connectors.
NOTE: There is a sleeve on the connector that will snap
when the connector is fully engaged with the mating
connector. The two cables will slide into each other only
when the connectors are properly aligned with each other.
Platform
Stacker Sensor
Switch
Label Stop
Rotary Knife
Assembly
Shafts
Nip Roller