beautypg.com

Addendum ii – short feed, Short feed o-ring replacement – Avery Dennison SNAP 700 User Manual

Page 147

background image

User’s Manual—SNAP™ 700 Printer

147

Addendum II – Short Feed

Machines equipped with short feed option use different parts noted after O-ring replacement instructions.
Machines with short feed option have ability to handle labels as short as .66” long.

O-rings on short feed nip rollers are wear items and require occasional changing. It is recommended to
change all O-rings at same time.

Short Feed O-Ring Replacement

1. Separate knife assembly from nip roller assembly by removing (2) nip assembly mount screws (shown
below.

KNIFE ASSEMBLY

NIP ROLLER ASSEMBLY

NIP ASSEMBLY MOUNT SCREW

2. Remove bridge blade and static brush from nip roller assembly by loosening (2) static brush thumb
screws. Remove any worn or damaged o-rings from rubber rollers and replace with new o-rings. Rubber
rollers are secured to nip roller brackets by tension from o-rings. Stretch o-rings over nip roller brackets,
then direct rubber roller ends to ½ slots on nip roller brackets. See below.

This manual is related to the following products: