2 printing, 3 handling the leader, 4 feeding the stock – Avery Dennison SNAP 700 User Manual
Page 31
User’s Manual—SNAP™ 700 Printer
31
Figure 11. Control Panel
3.3.2 Printing
Once a print job has been sent to the printer, the Data light will come on. You
can then press the Start/Stop Button to start printing.
When printing starts, the stacker will move the platform to the correct position.
Then the printer will start printing labels.
As the printer prints, the cut labels will drop onto the top of the stack. As the
stack grows, the stacker platform moves down so that the top of the stack stays
in the same position.
3.3.3 Handling the Leader
When you start printing for the first time, or after some errors, the printer will
create a leader. The leader is a longer piece of material that may be blank or
may have some partially printed labels. These labels are not usable and are not
part of the print job.
When the printer creates a leader, grab it as it comes out of the nip rollers and
pull it out of the stacker when the printer does the first cut. (If you are not using
the stacker, or you are using some other accessory such as a Rewinder, you
may need to handle the leader differently.)
3.3.4 Feeding the stock
To feed the tape, press and hold the Start/Stop button. After a short delay, the
printer will feed tape though the printer. To stop the feed, release the Start/Stop
button.