2 setting / adjusting voice button volume – Avery Dennison SNAP 700 User Manual
Page 38
38
User’s Manual—SNAP™ 700 Printer
8. Press and hold the Start / Stop and Voice buttons simultaneously to clear the
current batch of labels being printed.
9. The voice message will say, “Clearing Current Batch.” The Data light will go
out.
Test Pattern 3 and 4
The procedure for printing test pattern 3 and 4 is the same as described above.
3.5.2 Setting / Adjusting Voice Button Volume
The volume level of the voice messages on your SNAP 700 printer is set at Level
3 at the factory. If you want to adjust the voice button’s volume setting on your
printer, follow the steps listed below.
NOTE: When you select volume setting, the menu will
begin with the current volume at which your machine is
set, Level 3.
1. Press and hold the Voice button longer than two seconds to activate the
Option Menu System.
2. The voice message will say, “Press Start for Test Pattern.”
3. Press the Voice button. The voice message will say, “Press Start for
Demos.”
4. Press the Voice button. The voice message will say, “Press Start to Set
Volume.”
5. Press the Start / Stop button. The voice message says, “Press Start for
Volume Level 3.”
To increase from volume level 3 to 5, follow these additional steps.
6. Press the Voice button. The voice message says, “Press Start for Volume
Level 4.”
7. Press the Voice button. The voice message says, “Press Start for Volume
Level 5.”
8. Press the Start button. The voice message says, “Volume Set to Level 5.
Returning to Print Mode.”
NOTE: Each time you press the Start button, the volume
level will increase by one increment until the maximum
level is reached.