Avery Dennison SNAP 700 - Manual (Page 28)

28 User’s Manual—SNAP™ 700 Printer
Figure 10. Stock Supply Through Knife and Stacker
3.1.4 Butt Splice
CAUTION: To prevent damage to the print head, do not
use butt splices.
The SNAP 700 printer is designed to allow for fast, frequent changing and
loading of stock and ink. We recommend re-threading the stock rather than to
using a butt splice. If you determine that splicing is faster for threading, tape the
ends of the stock together. Turn the feed roller and advance the splice through
the printer. Do not try and run the splice through the printer as it can cause
damage.
Stock Web
Guide Knob
Upper Print
Roller
Lower Print
Roller
Stacker
Knife
Feed Roller