Setup and installation, Before you begin, Etup – ARRIS 2247-N8-10NA (v9.1.x) User Manual User Manual
Page 5: Nstallation
Motorola 2247-N8 DSL Wi-Fi Gateway User Guide
Please visit
www.motorola.com/us/support
for FAQs and additional product documentation.
5
Setup and Installation
Thank you for selecting the Motorola 2247-N8 DSL Wi-Fi Gateway. This guide
will help you install the 2247-N8, connect computers and other devices to it
using the 2247-N8’s wired (Ethernet) or wireless networking capabilities, and
connect to your existing DSL provider for Internet access.
TIP:
For rapid installation, configuration, and set up of wireless networking,
use the instructions on the included Quick Start Guide.
Advanced configuration instructions and basic troubleshooting are also pro-
vided in this User Guide. If you need additional information about the
2247-N8, or have configuration and use questions, go to
www.motorola.com/us/support
.
Quick Start Guide
Before you Begin
IMPORTANT:
You must have an existing DSL connection installed before
starting installation of the 2247-N8! You will also need the information below
from your DSL service provider:
PPP or PPPoE user name and password - This may be the e-mail user
name and password from your DSL provider’s service, or it may be a
customer identification name and password. If you are unsure, con-
tact your DSL provider.
VPI/VCI numbers used with your DSL service - In most cases the
2247-N8 will automatically detect this information. If you need to
enter it, refer to
“How to configure a Point to Point Protocol (PPPoE
or PPPoA) broadband connection:”
on page 47 of this User Guide.
Note:
Check the contents of the box to make sure you have all the items
shown to the right:
BEFORE RETURNING THIS PRODUCT TO THE STORE
for any reason, call
Motorola Broadband Technical Support at 1-877-466-8646.
Package Contents