ARRIS 2247-N8-10NA (v9.1.x) User Manual User Manual
Page 47

Motorola 2247-N8 DSL Wi-Fi Gateway User Guide
Please visit
www.motorola.com/us/support
for FAQs and additional product documentation.
47
How to -
configure a Point to Point Protocol (PPPoE or PPPoA) broadband connection:
Open the
Broadband > Configure
page.
The two supported Point to Point Protocol variants (PPP over Ethernet and PPP over ATM) are configured identically. Your service provider will be
able to tell you which protocol to select and what your username, password, VPI and VCI values are.
1. Click the
Connection Type
pull-down menu and choose the protocol supported by your service provider: PPPoE or PPPoA.
2. Type your service provider account credentials in the
PPP Username
and
PPP Password
fields. Retype your password exactly in the
Retype
Password
field for confirmation.
3. Click the
PPP Connection Type
pull-down menu and choose the way the 2247-N8 will connect to the broadband PPP network:
Always Attempt to Connect: The 2247-N8 will attempt to keep the broadband connection active at all times.
Connect Manually: The 2247-N8 will only connect when you manually enter broadband connection credentials from the
Broadband > Con-
figuration
or
Quickstart
pages.
Connect on Demand: The 2247-N8 will use stored PPP credentials to log in when a connected client device attempts to connect to a service
or device on the Internet, and will close the connection down after a period of activity.
4. Set the Domain Name Service (DNS), Network Address Translation (NAT) and bridging configuration of your 2247-N8:
If you want to use a DNS server not set by your service provider, set the
Use Received DNS Addresses
pull-down menu to Off. Type the
IP address of a DNS server in the
Primary DNS Address
field. If desired, type an alternate DNS server’s IP address in the
Secondary DNS
Address
field.
If you are using NAT (with a number of devices on a private wired or wireless network), set the
NAT Enable
pull-down menu to On.
If your ISP requires a routing device on the LAN side of your DSL gateway, turn
Bridging
On, otherwise, leave it Off.
5. Set Virtual Path and Channel Identifiers, either by automatically detecting them, or specifying values supplied by your service provider:
To have the 2247-N8 attempt to automatically detect and set the channel identifiers, click the
Automatic VPI/VCI Detection
pull-down
menu and select On (the default).