ARRIS 2247-N8-10NA (v9.1.x) User Manual - Manual (Page 36)

Motorola 2247-N8 DSL Wi-Fi Gateway User Guide
Please visit www.motorola.com/us/support for FAQs and additional product documentation. 36
How to - enable remote management access to your 2247-N8:
Open the System > Remote Access page.
1. Type a username and password combination in the Remote Access page. The password must be at least 8 characters long, and must include at
least two of the following types of characters:
Š alphabetic (letter) characters,
Š numeric (number) characters,
Š special characters (! @ # $ % ^ & * , etc)
2. If necessary, type a custom port number for HTTP access to the 2247-N8 remote access session in the Port field.
3. Set the time limits for remote access:
a. Click the User Inactivity Timeout pull-down menu and select a maximum time that the Remote Access session may be left idle before it is dis-
connected.
b. Click the Feature Duration Timeout pull-down menu and choose a time that the Remote Access feature will remain available. Set this number
to as low a value as you and the administrator or technician that will access your 2247-N8 feel is practical.
4. Click one of the Permissions selection buttons to set the type of remote access to allow:
Š Read/Write - allow the session to make changes to the 2247-N8 configuration.
Š Read Only - allow the remote access session to view, but not change, the configuration and collected statistics of the 2247-N8.
5. Click the Enable Remote Access button.
The 2247-N8 updates the Remote Access page and displays the current remote access settings, shows the URL that a remote access client must use
to connect to the remote access session, and provides a button for ending the remote access session. The remote access client will need to con-
nect to the URL shown on the Remote Access page, and will need to log in with the username “tech” and the password configured when access
was enabled.