ARRIS 2247-N8-10NA (v9.1.x) User Manual - Manual (Page 48)

Motorola 2247-N8 DSL Wi-Fi Gateway User Guide
Please visit www.motorola.com/us/support for FAQs and additional product documentation. 48
™ To manually enter VPI/VCI information from your service provider, click the Automatic VPI/VCI Detection pull-down menu and select Off,
then type the VPI and VCI values in the VPI and VCI input fields.
The most common VPI/VCI combinations are VPI:0 / VCI:35 and VPI:8 / VCI:35. Motorola recommends always using automatic VPI/VCI detection
first, and only manually setting VPI/VCI combinations if your service provider requires another circuit pair and provides the values.
6. Click the Save button to assign the new broadband configuration to the 2247-N8. The broadband interface resets and the 2247-N8 will go through
broadband negotiation.
How to - configure a DHCP Client assignment broadband connection:
Open the Broadband > Configure page.
If your service provider uses Dynamic Host Configuration Protocol (DHCP) to assign a configuration to the 2247-N8, use the following procedure to
set up your broadband connection.
1. Click the Connection Type pull-down menu and choose DHCP Client.
2. Set the Domain Name Service (DNS), Network Address Translation (NAT) and bridging configuration of your 2247-N8:
™ If you want to use a DNS server not set by your service provider, set the Use Received DNS Addresses pull-down menu to Off. Type the IP
address of a DNS server in the Primary DNS Address field. If desired, type an alternate DNS server’s IP address in the Secondary DNS
Address field.
™ If you are using NAT (with a number of devices on a private wired or wireless network), set the NAT Enable pull-down menu to On.
™ If your ISP requires a routing device on the LAN side of your DSL gateway, turn Bridging On, otherwise, leave it off.
3. Click the Save button to assign the new broadband configuration to the 2247-N8. The broadband interface resets and the 2247-N8 will go through
broadband negotiation.