ARRIS 2247-N8-10NA (v9.1.x) User Manual User Manual
Page 22
Motorola 2247-N8 DSL Wi-Fi Gateway User Guide
Please visit
www.motorola.com/us/support
for FAQs and additional product documentation.
22
Quickstart Broadband Configuration Fields
4. Click the
Connection Type
pull-down menu and click the type of DSL connection that your service provider supplied to your DSL enabled tele-
phone line:
PPPoE: for Point to Point Protocol over Ethernet broadband service. In the United States, PPPoE is the most common Point to Point Protocol
ADSL service type available.
PPPoA: for Point to Point Protocol over Asynchronous Transfer Mode (ATM) broadband service. If your service provider uses an ATM broad-
band connection to support your ADSL service, choose this selection.
DHCP Client: for an ADSL connection that uses Dynamic Host Configuration Protocol to configure the broadband connection type and settings
for the 2247-N8.
5. Type the user name assigned to you by your service provider in the
PPP Username
field.
Note:
the user name value may be a single word, or it may contain “@” symbols and periods (e.g: “[email protected]”).
6. Type the password that your service provider assigned when the ADSL connection was installed or set up in the
PPP Password
field. To confirm
that the password was entered correctly, type the password again in the
Retype Password
field.
7. Click the
Finish
button.
The Motorola 2247-N8 DSL Wi-Fi Gateway will attempt to make a connection to the service provider network. This process may take a few minutes,
and your Web management interface may update automatically to show you the
page during the process.
Note:
If the
Quickstart
page fails to connect to the service provider’s network, contact your service provider and double-check your user name and
password. If you are still having difficulty connecting, you may attempt the more detailed broadband configuration available on the
described on page 46.