Dataman 520 Series - Manual (Page 94)

DATAMAN oscilloscope
User’s Guide
- 94 -
Indicates WCD sensitivity. Value 255 indicates WCD switched off, 0 indicates the
biggest sensitivity.
8.2. Command lines parameters
There are several command line parameters available for the Scope application. You
just have to add the parameter to the icon target in the icon properties (change target
for example from "C:\Program Files\dataman\Scope\scope.exe" to "C:\Program
Files\dataman\Scope\scope.exe" -s "c:\program
files\dataman\Scope\Settings\default.st").
8.2.1. Selecting the settings loaded on application start
Parameter –s allows you to select the settings file that will be used during application
start. This file is not overwritten on application exit, so the application always starts
with the same settings.
Syntax: scope.exe –s “”
Example: "C:\Program Files\dataman\Scope\scope.exe" -s "c:\program
files\dataman\Scope\Settings\default.st"
The example uses the settings from the c:\program
files\dataman\Scope\Settings\default.st file. The settings file can be created by
selecting Settings | Save settings from main menu.
8.2.2. Selecting the type of device used
Parameter –d allows you to select the device type. Devices of all other types will be
ignored during initialization.
Syntax: scope.exe –d
Example: "C:\Program Files\dataman\Scope\scope.exe" –d 570
The example searches for and initializes only the DATAMAN 574 oscilloscope.
Allowed device types are as follows:
Parameter Device type
520 DATAMAN 522, 524, 526
570 DATAMAN 574
770 DATAMAN 774
Table 8.2.2.1. – Allowed device types of –d parameter