Dataman 520 Series - Manual (Page 78)

DATAMAN oscilloscope
User’s Guide
Fig. 6.11.1. – Waveform parameters window
The following parameters are displayed in the table:
„Peak-peak“ – peak-peak voltage
„Peak+“ – voltage of the maximum
„Peak-„ – voltage of the minimum
„Frequency“ – frequency
„RPM“ – frequency/60 (revolutions per minute)
„Period“ – period
„DC voltage“ – DC voltage
„Vrms“ – effective voltage
„Vavg“ – average voltage
„Crest factor“ – crest factor
If the module fails to detect the periodicity of the waveform, „N/A“ is displayed in
place of „Frequency“, „Period“, „DC voltage“, „Vrms“, „Vavg“, „Crest factor“.
„High
pulse width“ – high pulse width
„Low pulse width“ – low pulse width
„Duty factor“ – duty factor
„High pulse level“ – level of the high pulse
„Low pulse level“ – level of the low pulse
„High overshoot“ – overshoot of the leading edge
„Low overshoot“ – overshoot of the trailing edge
„Rise time“ – length of the leading edge
„Fall time“ – length of the trailing edge
If the module fails to detect the periodicity or rectangular shape of the waveform,
„N/A“ is displayed in place of „High pulse width“, „Low pulse width“, „Duty factor“,
- 78 -