Dataman 520 Series - Manual (Page 53)

DATAMAN oscilloscope
User’s Guide
Save/load | Save behaviour | Enable autosave option – Enables/disables checkbox on
the main screen, which turns autosave on/off. Check checkbox on the main window to
activate the mode in which the data is saved to disk automatically after they are
acquired.
Save/load | Load behaviour | Automatically increment filename – if the filename of
the source file ends with a number that number will be automatically incremented on
a successful load
Save/load | Load behaviour | Automatically apply settings – settings from the data file
will be automatically applied on successful load
Save/load | X and Y offset | Allow X offset change by dragging waveform – the X
offset of the loaded waveform can be changed by dragging the waveform on the
oscilloscope screen
Save/load | X and Y offset | Allow Y offset change by dragging waveform – the Y
offset of the loaded waveform can be changed by dragging the waveform on the
oscilloscope screen
Display | General | Tool tip help – activates tool tip help
Display | General | Separate hold of channel A and B – the standard „hold“ controls
on the main screen will be replaced by the ones which allow separate holding of
channel A and B
Display | Main screen | Allow display start change by dragging waveform – the
displayed part of the waveform on the oscilloscope screen can be changed by
dragging the waveform on the oscilloscope screen
Display | Main screen | Allow vertical shift change by dragging waveform – the
vertical shift can be changed by dragging waveform on the oscilloscope screen
Display | Main screen | Allow AT change by dragging mark – the after trigger amount
can be changed by dragging the trigger mark (red triangle)
Display | Main screen | Autoset trigger mode when dragging mark – when this option
is on the trigger mark drag automatically sets the trigger mode to „set“
Display | Main screen | Show information on main screen – the information about
timebase, range and vertical cursors‘ distance will be displayed on the main screen
Display | Main screen | Clear screen in single/manual mode on acq. start – the screen
is automatically cleared (all acquired waveforms are removed), when the acquisition
is started by clicking on the „flag“ button (single or manual trigger mode).
Display | Grid | Display ground level – turns display of the ground on the screen
on/off
- 53 -