Dataman 520 Series - Manual (Page 36)

DATAMAN oscilloscope
User’s Guide
If there are more than 500 samples displayed on the screen, one displayed sample has
to be calculated out of more than one measured sample. The samples are then
displayed as follows in this case:
If the button is activated, the displayed sample is calculated as an average of the
measured samples.
If the button is activated, the displayed sample is calculated as a maximum of the
measured samples.
If the button is activated, the displayed sample is calculated as a minimum of the
measured samples.
If both the button and button are activated, the line connecting the measured
sample with a maximum and minimum value is displayed.
The software can automatically select suitable display mode by analyzing input
waveform. Click button to activate/deactivate this.
TIP: The software selects correct display mode with high probability. We recommend
to use „Auto“ mode for most measurements.
Use the scrollbar in the bottom of the panel to change the used memory size.
4.1.7. Timebase controls
The timebase controls are located in the bottom of the main window.
Fig. 4.1.7.1. – Timebase controls
You can change the timebase using the scrollbar located in the bottom of the screen.
The following information is available above the divider:
- time of one screen division (used to acquire currently displayed data)
- time between trigger event and vertical cursor 1
- time between vertical cursors
- frequency between vertical cursors
The following information is available below the divider:
- time of one screen division (current settings)
- 36 -