Labconco PURICARE Procedure Station Models 31260 - Manual (Page 10)

Product Service 1-800-522-7658 10
Quickstart
How do I recalibrate the
 blower speed
 filter life gauge
 airflow sensor reading
of the Logic+?
1. Press the Menu button.
2. Press the ▼ button until the Services option is highlighted (it will
turn yellow).
3. Press OK/Mute to enter the Services menu screen.
4.
Press the ▼ button until the Calibration option is highlighted (it
will turn white).
5. Press OK/Mute to start the calibration procedure.
6.
You will see a warning screen alerting you that you are about to
alter the BSC’s settings.
7. Press OK/Mute to input the password.
8. When requested for the password press Light , UV light ,
Timer , Timer then OK/Mute .
9. If the password is properly entered, the first certification screen
will display the blower motor’s PWM setting.
10. Press the ▲ or ▼ button to increase or decrease the blower
speed as needed. When the speed is set properly, press the
OK/Mute button to lock the new blower speed setting, and
continue to the filter life screen.
MAIN MENU
1. MyLogic TM
2. Settings
3. Service
  or to choose,
OK to select, MENU to escape
or to choose,
OK to select, MENU to return
 Current Settings
Restore Default
Diagnostics
Configuration
Calibration
 
Service
ATTENTION!
The following screens are used
to alter the operation of the
Logic. They should only be used
by a qualified certifier as part
of the certification process.
Calibration
OK to proceed, MENU to return
PASSWORD:
Calibration
The ECM setting is: 80
The current RPM is: 1050
The average RPM is: 1020
Calibration
Motor Speed Adjustment
or to change motor speed,
OK to select, MENU to finish
 