East Coast Supercharging Lysholm 2010+ Camaro Supercharger Kit User Manual

Page 38

P/N: 4LGE020-010 v1.1, 2011-04-29

Fig 3K

Fig 3L

G. Locate the previously removed coil pack

assembly and modify as follows:

1. Unclip the wiring harness conduit from

the coil bracket. Removing the ignition

coil adjacent to the main plug will aid in

removal. See fig 3J.

2. Locate the supplied coil bracket reloca-

tion heat shield and place on coil bracket

as shown.

3. Transfer the three (3) holes from the

relocation heat shield onto the coil brack-

et. See fig 3K.

4. Using a 5/16” drill bit, drill through the

three (3) marked locations on the coil

bracket. The main connector plug may

need to be removed to avoid damage

during drilling. Remove burrs/sharp

edges. See fig 3L.

Fig 3J

NOTE: Use of a sharp drill and proper lubrication will aid in

drilling through the steel OEM bracket.