East Coast Supercharging Lysholm 2010+ Camaro Supercharger Kit User Manual

Page 12

P/N: 4LGE020-010 v1.1, 2011-04-29

B. Disconnect the negative battery terminal

(located in the trunk) using a 10mm socket.

Remove the trunk carpet, loosen the large

plastic wing nut in the center of the floor and

lift the trunk floor out. Remove the tire repair

kit to reveal the battery. See fig 1C.

C. Remove the oil fill cap on the passenger side

valve cover to allow removal of the engine

cover. Lift the engine cover from the front

and then pull it out toward the front of the

vehicle. Temporarily reinstall the oil fill cap to

prevent contamination.

D. Remove the nut securing the black plastic

engine cover support to the rear section of

the intake manifold. Pivot the support upward

and snap it off of the passenger side fuel rail.

See fig 1D.

E. Disconnect the MAF electrical connector from

the meter in the intake air tube as shown in

See fig. 1E.

Fig 1C

Fig 1D

Fig 1E