East Coast Supercharging ECS Stage 1 2003+ Fuel System - Manual

ECS Stage I Fuel System Instructions
The ECS Stage I fuel System is designed for late model Corvettes not exceeding 750 RWHP.
The System comes with a ECS Made custom in tank fitting, A Bosch 044 fuel pump, braided 8 AN fuel
line, an assortment of anodized fittings, a check valve, and a fuel line adapter. The entire system installs
in the rear of the car without the need to drop the tank.
You are working with Fuel. Be mindful of any sources of heat, sparks or any other conditions that could
cause a fire. ECS cannot and will not be held responsible for any damages caused by installation.
Start with an empty fuel tank.
Disconnect the negative battery cable.
With the car on a lift or jackstands, remove the driver’s side rear wheel and inner fender
liner.
Using a file or wiz wheel with a Roll Lock sanding disk, prepare the exterior surface of the driver’s side
tank to be sure that the surface is flush and true.
Approximately 3 inches from seam and 2 ¾ inches from
bottom of tank make a mark where you will be drilling for
the ECS in tank auxiliary fuel pick up assembly.