East Coast Supercharging Lysholm 2010+ Camaro Supercharger Kit - Manual (Page 11)

P/N: 4LGE020-010 v1.1, 2011-04-29
© 2011 Lysholm
All Rights Reserved, Intl. Copr. Secured
1
A. Remove the Front Bumper Cover (FBC):
1. Remove the two (2) 10mm-headed
screws from the bottom of the FBC.
2. Remove three (3) T20 Torx screws
securing each splash guard to the FBC
(6 total). These screws are located in
the wheel wells just forward of the front
wheels along the outer edge.
3. Remove two (2) of the plastic pins
securing each splash guard to the inner
fender structure (4 total). One is adja-
cent to the strut and the other is directly
above the wheel.
4. Pull the splash shield away so it rests
against the tire, revealing the fasteners
at the leading edge of the fender as
shown in Figure 1A.
5. Remove the four (4) 10mm-headed
screws and one (1) 7mm-headed screw
attaching the FBC to the leading edge of
the fender on each side (See fig. 1B, LH
side shown).
6. Disconnect the FBC electrical connector
located between the passenger side
driving light and headlight. Access the
connector via the wheel well.
7. Remove the two (2) 10mm-headed
screws and six (6) plastic pins along the
top edge of the FBC.
8. Remove the FBC by sliding it forward
and away from the car.
1. PREPARATION / REMOVAL
Fig 1A
Fig 1B
10MM SCREWS
7MM SCREW