D-Link DES-3018 - Manual (Page 86)

DES-3010F/DES-3010FL/DES-3010G/DES-3016/DES-3018/DES-3026 Fast Ethernet Switch Manual
73
Multicast Forwarding
The following figure and table describes how to set up Multicast Forwarding on the Switch. To view this
window click Administration > Forwarding & Filtering > Multicast Forwarding
Figure 6- 57. Static Multicast Forwarding Settings and Current Multicast Forwarding Entries window
The Static Multicast Forwarding Settings page displays all of the entries made into the Switch's static
multicast forwarding table. Click the Add button to open the Setup Static Multicast Forwarding Table, as
shown below:
Figure 6- 58. Setup Static Multicast Forwarding Table - Add
The following parameters can be set:
Parameter Description
VID The VLAN ID of the VLAN to which the corresponding MAC address belongs.
Multicast MAC
Address The MAC address of the static source of multicast packets. This must be a multicast MAC
address.
Port Settings Allows the selection of ports that will be members of the static multicast group. The options
are:
None - No restrictions on the port dynamically joining the multicast group. When None is
chosen, the port will not be a member of the Static Multicast Group.
Egress - The port is a static member of the multicast group.
Click Apply to implement the changes made. To delete an entry in the Static Multicast Forwarding Table,
click the corresponding under the Delete heading. Click the
Show All Multicast Forwarding Entries link to
return to the Static Multicast Forwarding Settings window.