Aiwa XR-H330MD - Manual (Page 7)

SOUND
■GEQ
44
—
T-BASS
,Ei VOL
■SHIFT
ROCK/POP/CLASSIC
VOLUME
Turn VOLUME on the main unit, or press VOL on the remote
control.
The volume level is displayed as a number from 0 to 49 followed
by MAX.
The volume level is automatically set to 20 when the power is
turned off while the volume level is set to 21 or more.
Q SURROUND SYSTEM
The Q SURROUND system built into this unit uses only two
speakers at the left and right to create an atmosphere that sound
as if you are surrounded by two front speakers and two rear
speakers.
Press Q SURROUND on the main unit to light up "Q
SURROUND" in the display window.
Displayed for 4 seconds.
;■ ■■......i 1r; ;
Lights.
To cancel the Q SURROUND effect
Press Q SURROUND again.
’ The Q SURROUND system does not work in monaural mode.
■ Setting of T-BASS, graphic equalizer or Q SURROUND has
no effect on tape recording or MD recording.
V>
Z
0
g
a
1
UJ
cc
a.
a
z
o
o
V)
SUFFER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press T-BASS.
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
GRAPHIC EQUALIZER
This unit provides the following three different equalization curves.
ROCK: Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
CLASSIC: Enriched sound with heavy bass and fine treble
Press ROCK, POP or CLASSIC.
The selected equalization mode is displayed for 4 seconds.
I
(OFF)
Lights. Displayed for 4 seconds.
ROCK
To s€!lect with the remote control
Press T-BASS while pressing SHIFT.
Low frequency sound may be distorted when the T-BASS system
is used for a disc or tape in which low frequency sound is originally
emphasized. In this case, cancel the T-BASS system.
To cancel the selected mode
Press the selected button again. "GEQ OFF" is displayed for 4
seconds.
To select with the remote control
Press GEQ repeatedly while pressing SHIFT.The GEQ mode is
displayed cyclically as follows.
ROCK POP- CLASSIC GEQ OFF -
(cancel)
Using the headphones
Connect headphones to PHONES jack with a stereo standard
plug (oG.3 mm, 'Ainch).
No sound is output from the speakers while the headphones are
plugged in.
Sound adjustment during recording
The output volume and tone of the speakers or headphones may
be freely varied without affecting the recording.
ENGLISH
7