Aiwa XR-H330MD - Manual (Page 38)

Main unit CX-NH330MD
FM tuner section
Tuning range
Usable sensitivity (IHF)
Antenna terminals
AM tuner section
Tuning range
Usable sensitivity
Antenna
Amplifier section
Mid-high frequency amplifier
Power output*
Total harmonic distortion
Low frequency amplifier
Power output*
87.5 MHz to 108 MHz
16.8 dBf
75 ohms (unbalanced)
530 kHz to 1710 kHz (10 kHz step)
531 kHz to 1602 kHz (9 kHz step)
350 pV/m
Loop antenna
10 watts per channel, Min.
RMS at 8 ohms, from 200 Hz to
20 kHz, with no more than 1%
Total Harmonic Distortion
0.06 % (8 W, 1 kHz, 8 ohms, DIN
AUDIO)
Total harmonic distortion
Inputs
Outputs
30 watts per channel, Min.
RMS at 4 ohms, from 50 Hz to
200 Hz, with no more than 1%
Total Harmonic Distortion
0.06 % (20 W, 135 Hz, 4 ohms, DIN
AUDIO)
without connecting to the SURROUND SPEAKERS
VIDEO/AUX: 310 mV
DIGITAL IN
SPEAKERS:
LOW FREQ: accept speakers of 4
ohms
HIGH FREQ: accept speakers of 8
ohms
SURROUND SPEAKERS: accept
speakers of 8 to 16 ohms
PHONES (stereo jack): accepts
headphones of 32 ohms or more
CD DIGITAL OUT (OPTICAL) jack
Compact disc player section
Laser
D-A converter
Signal-to-noise ratio
Harmonic distortion
Wow and flutter
MD recorder section
Scanning method
Recording system
Rotation speed
Samnllna frequency
No. of channels
A-D, D-A converter
Frequency
Wow and flutter
Semiconductor laser {X = 780 nm)
1 bit dual
85dB(1 kHz, OdB)
0.05 % (1 kHz, 0 dB)
Unmeasurable
Non-contact optical scanner
(Semiconductor laser application)
Magnetic polarity modulation
overwrite system
Approx. 400 - 900 rpm (CLV)
44.1 kHz
Stereo: 2 channels
Monaural: 1 channel
1-bit
20 to 20000 Hz +0.5 - -1.5 dB
Unmeasurable
General
Power requirements
Power consumption
Standby power consumption
Dimensions of main unit
(W X H X D)
Weight of main unit
120 VAC, 60 Hz
130 W
1.3 W (power-economizing mode
set to ON)
260 X 329.5 X 354.5 mm
(10 V4 X 13 X 14 in.)
8.6 kg (18lb5oz.)
Speaker system SX-WNH330
Cabinet type
Speakers
Impedance
Output sound pressure level
Dimensions (W x H x D)
Weight
3 way, built-in subwoofer (magnetic
shielded type)
Subwoofer:
160 mm cone type
Full range:
100 mm cone type
Super tweeter;
20 mm ceramic type
LOW FREQ: 4 ohms
HIGH FREQ: 8 ohms
87 dB/W/m
240
X 324 X 270 mm
4.8 kg
Specifications and external appearance are subject to change without
notice.
•US AND FOREIGN PATENTS LICENSED FROM DOLBY
LABORATORIES LICENSING CORPORATION.
COPYRIGHT
Please check the laws on copyright relating to recordings from
discs, radio or external tape for the country in which the machine
is being used.
NOTE
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions,
may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
CAUTION
Modifications or adjustments to this product, which are not
expressly approved by the manufacturer, may void the user's
right or authority to operate this product.
Cassette deck section
Track format
Frequency response
Recording system
Heads
4 tracks, 2 channels stereo
50 Hz to 15000 Hz
AC bias
Deck 1: Playback head x 1
Deck 2:Recording/playback head
x 1, erase head x 1
38 ENGLISH