Aiwa XR-H330MD - Manual (Page 34)

The display window brightness can be adjusted to the tollowing
four levels: "DIM-OFF", "DIMMER 1", "DIMMER
2", and
"DIMMERS".
"DIM-OFF" is the brightest level.
When "DIMMER 3" is selected, the display is darkest, the
illumination of CD tray and slot of MD disc drive goes out, and
the spectrum analyzer does not move.
Setting this unit to power economizing mode reduces power
consumption as follows.
• When the power shuts off, all indications of the display window
are turned off.
(Even the clock is not displayed. When the AC cord is connected
to the AC outlet, only the red indicator below the POWER button
lights. Note, however, that the demo display will appear unless
the clock of the unit is set. For the demo display, see page 6.)
• If the tape, CD, and MD are stopped and there is no audio
input from any connected external equipment for 10 minutes,
the power shuts off.
• When the power turns on by timer recording (page 31), the
display window brightness level is set to "DIMMER 3", all button
lamps are off, and the volume is set to the minimum level.
• The display window brightens only when the unit is being
operated. When the unit has not been operated for 10 seconds,
the brightness level switches to the level chosen by the "DIM
MODE" setting.
(If the brightness level is set to "DIM-OFF", the brightness does
not change. When the level is "DIMMER 3", the button lamps
are also turned off.)
1 Press ECO.
"ECO MODE?" is displayed.
1 Press ECO.
"ECO MODE?" is displayed.
2 Within 4 seconds, turn MULTI JOG to display "DIM
MODE?".
Din NÜDE
3 Within 4 seconds, press ENTER.
Selected brightness is displayed.
4 Within 4 seconds, turn MULTI JOG to select your
desired brightness.
C
DIM-OFF
DIMMER 3
DIMMER 1
DIMMER 2
After 4 seconds, the brightness level selected will be set
automatically.
Or, it you press ENTER within 4 seconds, the brightness level
selected will be set.
1
..ECO MiJDE
2 Within 4 seconds, press ENTER.
The current power-economizing mode status will be displayed.
If the power-economizing mode is OFF: ECO OFF
If the power-economizing mode is ON: ECO ON
3 Within 4 seconds, turn MULTI JOG to switch the
power-economizing mode on or off.
Example: When "ON" is selected
...ECL
---- ,
After 4 seconds, the power-economizing mode selected will be
set automatically.
Or, if you press ENTER within 4 seconds, the power-economizing
mode selected will be set.
Standby power consumption
If the power-economizing mode is OFF: 24 W
If the power-economizing mode is ON: 1.3 W
After timer recording (page 31) with the power-economizing mode
set to ON, if you turn on the power, the display window brightness
level is set to "DIMMER 3", all button lamps are off, and the
volume is set to the minimum level. If necessary, adjust the
volume and the display window brightness level again.
34
ENGLISH