Inserting batteries, When to replace the batteries, To use the remote control – Aiwa XR-H330MD User Manual
Page 6: To turn the unit on press power, To turn the unit off press power again, If the power is turned off after the clock is set, To turn off the cd compartment light, To turn off the md compartment light, To use function on the remote control, Concerning the display window's demo display
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
To use the remote control
• Buttons on the remote control with the same names as those
on the main unit can be used instead. There are operations
performed by both the main unit and the remote control, but
there also exist operations performed by the remote control
only.
Read this manual for each operation and the buttons that can
be used.
• Some buttons on the remote control have two different functions.
To use the function on the button, simply press the button. To
use the function on the plate above or below the button, press
the button while pressing SHIFT.
ra
C 0
o
. o J u II
<0 ^
If
SHIFT-
To turn the unit on
Press POWER.
To turn the unit off
Press POWER again.
If the power is turned off after the clock is set
The red indicator below the power button lights to indicate that
power is supplied. Nothing is displayed on the display window
(setting when you purchase the unit).
To turn off the CD compartment light
Press the ■ button while pressing the CD button. Repeat the
same operation to restore the light.
To turn off the MD compartment light
Press the ■ button while pressing the MD button. Repeat the
same operation to restore the light.
153^
When you purchase this unit, the power economizing mode
is set to ON.
If the tape, CD, and MD are stopped and there is no audio
input from any connected external equipment for 10 minutes,
the power shuts off. To set the power economizing mode to
OFF, see page 34.
To use FUNCTION on the remote control
FUNCTION substitutes for the function buttons (TAPE (1, 2),
TUNER (FM, AM), AUX, D-IN, CD, MD) on the main unit.
Each time FUNCTION is pressed, the next function is selected
cyclically. When tapes are inserted in both decks, both decks
can be selected with FUNCTION.
NOTE
■
If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
■
The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
CONCERNING THE DISPLAY WINDOW'S
DEMO DISPLAY
When the power cord is plugged into an electrical outlet for the
first time after purchase, a demo display will appear in the display
window. When the power is turned on, the demo display will end.
When the power is turned off, the demo display will appear again.
Until the clock is set, the demo display will appear whenever the
power is turned off.
When the clock is set
Normally, the demo display will not appear,
if is pressed when the power is off, the demo display will
appear. To end the demo display, press ◄►. (For setting the
clock, see page 31.)
After the power is turned on
Display of source and volume level flashes for 4 seconds while
the unit is being powered on.
During this period, the unit cannot be operated.
6
ENGLISH