Aiwa XR-H330MD - Manual (Page 20)

MD RECORDING
The sound of the CD does not decline in quality on the recording,
and recording can be done easily with the CD ► MD button.
Registering index marks automaticaiiy
The track order information in the original CD will be copied as
the index marks.
DISC
DIRECT
PLAY
■PRGM
■ Numbered
buttons
■SHIFT
1 Insert a recordable MD into the disc drive with
the label side up and in the direction of the arrow.
• Insert an MD only when the unit is turned on.
Arrow mark
2 Press CD and load a CD to be recorded on tray 1.
3 Press CD ► MD once to start recording.
"► MDdirect" is displayed and recording begins.
s,
¿Cl :i...r;et
During recording, display changes to the elapsed playing time.
When the last track of the CD finishes playing, the recording
stops automaticaiiy.
When the recording finishes, "TOC EDIT" is displayed and
the data concerning the contents of the recording are
registered.
Digital recording is performed by pressing CD^MD. For
analog recording, see page 22.
To check the remaining recordabie time of the MD before
recording starts
Press MD, then press CD EDiT/CHECK on the remote control
while pressing SHIFT. Or, press one of the function buttons except
MD, then press DISPLAY on the main unit. The remaining
recordable time is displayed for 4 seconds.
To stop recording halfway
Press ■. The recording stops and TOC data is registered.
To stop playing the CD, press ■ again.
To record on a previously recorded MD
If there is an unrecorded section left on the MD, the new recording
automatically starts from where the previous recording finished.
If you want to start recording from the beginning of a previously
recorded MD, erase the previous recording completely. (See
page 30.)
RECORDING ONL
1
j
1 Insert a recordable MD into the disc drive with
the label side up and in the direction of the arrow.
2 Press CD and piay the track of the CD to be
recorded.
3 Press CD ► MD once to start recording.
CD playing returns to the beginning of the current playing
track and recording begins.
When the selected track of the CD finishes playing, the
recording stops automatically and the CD playback continues
to the next track. To stop playing the CD, press ■.
When the recording finishes, "TOC EDIT" is displayed and
the data concerning the contents of the recording are
registered.
• The index mark is registered automatically at the beginning
of the track.
■ While "TOC EDIT" is displayed, do not disconnect the AC cord
or shake the unit. Otherwise, the TOC data is not registered
properly.
' During recording with CD ► MD, II cannot be used.
' Nothing other than an MD should be inserted into the disc drive.
Otherwise the disc may become scratched, causing a
malfunction or safety hazard such as an electric shock.
' Do not attempt to insert another MD while an MD is already
inside the disc drive.
■ Do not tilt the unit with a disc inserted. Doing so may cause
malfunction.
■ In digital recording, if there is a blank section lasting more than
4 seconds, only 4 seconds of blank section may be recorded.
(An index mark is registered automatioally when the next sound
signal is input thereafter.)
20
ENGLISH