1 inisert a recordable md into the disc drive with, 2 press one of the function buttons and prepare, Thi5 source to be recorded – Aiwa XR-H330MD User Manual
Page 23: 3 press mode twice, 6 press • md rec, 7 press ii to start recording, 8 press ■ to stop recording, 5 within 10 seconds, press enter, Oc o
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4,5
MULTI JOG ■
3
7
8
1
1 Inisert a recordable MD into the disc drive with
the label side up and in the direction of the arrow.
2 Press one of the function buttons and prepare
thi5 source to be recorded.
• To record from a tape, press TAPE and insert a tape.
• To record from the radio, press TUNER BAND and tune in
a station.
• To record from a source equipment connected to
DiGiTAL iN jack on the rear, press AUX/D-iN repeatedly
until "D-IN" appears on the display.
• To record from a source equipment connected to VÌDEO/
AUX jacks on the rear, press AUX/D-iN repeatedly until
"ytUX" appears on the display.
3 Press MODE twice.
"M ark MODE?" is displayed for 10 seconds.
6 Press • MD REC.
Unit enters the standby mode. Wait until the source name to
be recorded is displayed.
O'"
O
z
5
oc
o
o
III
DC
O
S
7 Press
II
to start recording.
To record from a connected equipment, set the equipment to
playback mode.
8 Press ■ to stop recording.
When the recording finishes, "TOC EDIT" is displayed and
the data concerning the contents of the recording are
registered.
To add index marks during recording
Press ENTER at the desired point during recording.
Or, press MDTiTLE/ENTER on the remote control while pressing
SHIFT.
' There may be a case where index marks are not registered
accurately even if the AUTO MARK is selected.
' You cannot register index marks without registering track
numbers.
' If you pause recording, the track number does not increase.
c
n a
A O D b a
4 Within 10 seconds, press ENTER and turn MULTI
JOG to select an index mark mode.
To register index marks automaticaliy at the beginning
of
sach
track, select "Mark;AUTO?".
To register index marks every 5 minutes, select
"MarkiTIME?".
To register without index marks, select "Mark:OFF?".
5 Within 10 seconds, press ENTER.
Selected mark mode
r
\
To prevent accidental erasure of recorded material
Slide the record-protect tab as shown below.
Slide the tab so that it is completely locked.
If a recording is attempted when the tab is set to the protected
position, "Protected" appears on the display. Slide the record-
protect tab to the original position.
ENGLISH
23