Potter PFC-6030 - Manual (Page 40)

3-34
PFC-6030 • 5403595 • Rev C • 2/13
Setting Addresses
The FIB-1000's address is set by dip switch S1, which is located on the back of the board. The address must be set in the range
of one to thirty (1–30) to be recognized by the panel. (Refer to the "P-Link Addresses" table shown earlier in this section for DIP
switch programming.)
FIB-1000 Back Panel Showing Dip Switch Location Figure 47.
Serial Parallel Gateway Installation (SPG-1000)
An optional SPG-1000 serial/parallel gateway (printer drive) board can be mounted inside the Ae-8 or Ae-14 accessory
enclosure, or the Ae-RM rack mount enclosure kit. The SPG-1000RM includes a standard 19 inch rack-mount enclosure, which
can then be installed directly in an equipment rack. Up to thirty-one (31) printers may be installed on this panel.
SPG-1000 Serial Parallel Gateway Board & Rack Mount Figure 48.
SPG-1000 Wiring to Control Panel Example Figure 49.
DWG #608-16 DWG #608-15
DWG #608-24
Dip Switches
P-Link
Connections
S1
DWG #608-26
P-Link
- + A B
P-Link from
control panel
Example:
Powered by
control panel