Ip csg psd drain delay – Cisco OL-15491-01 User Manual
Page 91
A-91
Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
OL-15491-01
Appendix A CSG2 Command Reference
ip csg psd drain delay
ip csg psd drain delay
To define the delay interval, in seconds, before draining packets from the Cisco Persistent Storage
Device (PSD) when the Billing Mediation Agent (BMA) becomes active, use the ip csg psd drain delay
command in global configuration mode. To delete the drain delay interval, use the no form of this
command.
ip csg psd drain delay number-of-seconds
no ip csg psd drain delay
Syntax Description
Defaults
The default value is 1 second.
Command Modes
Global configuration
Command History
Usage Guidelines
The CSG2 can buffer GTP’ messages in the Cisco Persistent Storage Device (PSD), if so configured.
(For more information, see the
“Configuring PSD Support” section on page 7-1
.) By default, the CSG2
limits the rate at which GTP’ messages are read from the PSD to 500 packets/second. However, you can
use the ip csg psd drain delay command to change that rate. For example, specifying an interval of
2 seconds yields a rate of 250 packets/second (500 packets/2 seconds).
Examples
The following example shows how to specify a PSD drain delay interval of 2 seconds:
ip csg psd drain delay 2
Related Commands
number-of-seconds
Delay interval, in seconds, before draining packets from the PSD. The range
is 0 to 3. The default value is 1. A value of 0 means no delay.
Release
Modification
12.4(11)MD
This command was introduced.
Command
Description
Configures a Cisco Persistent Storage Device (PSD).
Defines the number of packets to be drained from the Cisco
Persistent Storage Device (PSD) per drain delay interval when the
Billing Mediation Agent (BMA) becomes active.