Meter initial – Cisco OL-15491-01 User Manual
Page 201
A-201
Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
OL-15491-01
Appendix A CSG2 Command Reference
meter initial
meter initial
To specify the initial quota debited by the CSG2 from the balance at the beginning of a service when the
service is configured for Service Duration Billing, use the meter initial command in CSG2 service
configuration mode. To restore the default behavior, use the no form of the command.
meter initial value
no meter initial value
Syntax Description
Defaults
The default quota is 0 quadrans.
Command Modes
CSG2 service configuration
Command History
Usage Guidelines
This command allows “connection setup charges” to be applied to a service.
The debit occurs when the CSG2 grants the first access for the service. The initial value is not rounded
up to the nearest increment value.
Examples
The following example shows how to configure an initial quota debit for the OFF_NET service.
ip csg service OFF_NET
meter initial 60
Related Commands
value
Initial quota, in quadrans, debited from the balance at the beginning
of a service when the service is configured for Service Duration
Billing. The debit occurs when the CSG2 grants the first network
access for a session that has been mapped to the service. The initial
value is not rounded up to the nearest increment value.
The range is from 0 to 65535. The default value is 0.
Release
Modification
12.4(11)MD
This command was migrated from CSG1.
Changes from CSG1: None.
Command
Description
Configures a CSG2 content billing service, and enters CSG2
service configuration mode.
Excludes call control packets for a Session Initiation Protocol
(SIP) session from the CSG2 usage calculation.