Cisco OL-15491-01 User Manual

Page 35

A-35

Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide

OL-15491-01

Appendix A CSG2 Command Reference

flags

•

0x80: Connection terminated because of lack of authorization failure.

–

0: The connection was not terminated as a result of an authorization failure.

–

1: The connection was terminated as a result of an authorization failure.

•

0x7E: Reserved.

The tcp flag values are:

•

0x01: Connection initiator.

–

0: The connection was initiated by the subscriber. The source address is associated with the user
ID.

–

1: The connection was initiated by the network. The destination address is associated with the
user ID.

•

0x02: TCP termination type.

–

0: Normal TCP termination (FIN or RST).

–

1: Connection timed out.

•

0x04: Persistent Connection (multiple sequential transactions per TCP connection).

–

0: The reported connection is not a persistent connection.

–

1: The reported connection is a persistent connection.

•

0x08: Destination Initiated Close (valid only if TCP termination type is 0).

–

0: The connection teardown was initiated by the source IP in the flow.

–

1: The connection teardown was initiated by the destination IP in the flow.

•

0x10: Destination Side FIN (valid only if TCP termination type is 0).

–

0: The destination side never sent a FIN (it might have sent an RST).

–

1: The destination side sent a FIN.

•

0x20: Source Side FIN (valid only if TCP termination type is 0).

–

0: The source side never sent a FIN (it might have sent an RST).

–

1: The source side sent a FIN.

•

0x40: Connection not closed (valid only for HTTP 1.1).

–

0: The connection has been closed.

–

1: The connection is not closed yet, and TCP close bits have no meaning.

•

0x80: Connection terminated because of lack of authorization failure.

–

0: The connection was not terminated as a result of an authorization failure.

–

1: The connection was terminated as a result of an authorization failure.

The wap flag values are:

•

0x00: Normal.

•

0x01: Aborted.

•

0x02: Incomplete.

•

0x04: Forced abort.