Port (iscsi) – Cisco OL-15491-01 User Manual
Page 219
A-219
Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
OL-15491-01
Appendix A CSG2 Command Reference
port (iSCSI)
port (iSCSI)
To specify the number of the port on which to listen for iSCSI traffic in the iSCSI target interface profile
on the CSG2, use the port command in iSCSI configuration mode. To remove the port number, use the
no form of the command.
port port-number
no port port-number
Syntax Description
Command Default
No default behavior or values.
Command Modes
iSCSI configuration
Command History
Examples
The following example configures an iSCSI target interface profile with the name targetA to a iSCSI
target with which the CSG2 will communicate using port number 3260:
ip iscsi target-profile targetA
name iqn.2002-10.edu.abc.iol.iscsi.draft20-target:1
ip 10.0.0.1
port 3260
session-timeout 120
target-portal 1
Related Commands
port-number
Number of the port on which to listen for iSCSI traffic. We recommend that
you use port 3260.
Release
Modification
12.4(15)MD
This command was introduced.
Command
Description
Specifies the IP address of an iSCSI target in the target
interface profile on the CSG2.
Defines the delay interval, in seconds, before draining
packets from the Storage Area Network (SAN) connected to
the Internet Small Computer Systems Interface (iSCSI)
when the Billing Mediation Agent (BMA) becomes active.
Defines the number of packets to be drained from the
Storage Area Network (SAN) connected to the Internet
Small Computer Systems Interface (iSCSI) per drain delay
interval when the Billing Mediation Agent (BMA) becomes
active.